EasyManua.ls Logo

TurboChef NGO/SOTA - Menu Updates and Recipe Editing

TurboChef NGO/SOTA
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 INFO
,
TEST
, AND EDIT MODE
Upda
ting the O
ven Menu
NOTE: If your oven receives updates from Oven
Connect
TM
, then manually updating the menu is
not r
ecommended.
NO
TE: To update a menu, you may need to verify
that access to the Load M
enu scr
een is turned on.
S
ee the
S
et Options Screen
section on page 12 for
mor
e details.
T
o load a menu to the o
ven,
1.
Go to screen 2 of the Info Mode (Figure 13,
page 11).
2.
Press the R1 soft key to access the Load
M
enu screen (Figure 23).
3. Insert the smart card (Figure 24).
-
White for SOTA
- Gray for SBK NGO
4. Press the L1 soft key (Figure 23).
5. Verify the oven beeps and reads FINISHED.
M
aking a Copy of the Oven Menu
NO
TE: To make a copy of the oven menu, you
may need to v
erify that access to the Load Menu
screen is turned on. See the Set Options Screen
section on page 12 for mor
e details.
To save a copy of the menu to a smart card,
1.
Go to screen 2 of the Info Mode (Figure 13,
page 11).
2.
P
ress the R1 soft key to access the Load
Menu screen (Figure 23).
3. Insert the smart card (Figure 24).
-
White for SOTA
-
G
ray for SBK NGO
4. Press the L2 soft key (Figure 23).
5. Verify the oven beeps and reads FINISHED.
Upda
ting the O
ven Firmware
CA
UTION: The oven will be inoperable if
the firmwar
e update is unsuccessful!
F
r
om the Oven Off screen,
1.
Insert the gray smart card “1 of 3” (Figure 24).
2.
When the o
ven is cooling down or off, press
and hold the Info key until the oven resets
(appr
o
ximately 5 seconds).
3. The oven will produce a series of short beeps.
When the o
v
en beeps one long tone, insert
car
d “2 of 3.
4.
The oven will again produce a series of short
beeps.
When the oven beeps one long tone,
insert card “3 of 3.
5.
The oven will again produce a series of short
beeps. When the oven beeps one long tone,
remove the smart card.
6. The oven will restart, indicating the update is
complete.
NOTE: If the update is unsuccessful, the display
will remain off and the oven will beep one long,
low tone. If the update fails multiple times,
contact TurboChef as a card may be damaged.
F
igur
e 24: Inserting Smart Card
Smart Card
Smar
t C
ard Reader Slot
Figure 23: Loading...Finished
R1
R2
R3
R4
L1
L2
L3
L4

Table of Contents

Related product manuals