TurboChef NGO/SOTA - Volt on; Changing Temperature Measurement Setting; Erase;Default Oven Settings

INFO, TEST, AND EDIT MODE
15
Volt On
This setting should not be changed in the field
unless instructed by TurboChef. Press the R2 soft
key (F
igur
e 17, page 14) to enable/disable the
voltage from displaying in Info Mode. Typically,
this setting is disabled for o
v
ens installed outside
the United States.
Changing Temperature Measurement Setting
P
ress the R4 soft key (Figure 17, page 14) to change
the temperature measurement to Fahrenheit or
Celsius.
Er
ase/Default Oven Settings
CAUTION: Settings cannot be retrieved once
an erase option is confirmed.
P
ress the R3 soft key (Figure 17, page 14) to access
the “E
rase” screen (Figure 22). From the “Erase”
screen,
-
Press the L2 soft key to erase counters and
fault logs.
- Press the R2 soft key to erase counters, fault
logs, menu settings, temperatur
e settings, serial
number, date, and time. Doing so will also
default all o
v
en options (page 12 for more
detail) to OFF
, with the exception of “load
menu.”
F
igure 21: Self Test Screen
AUTO T EST
MAG TEST
BLOWER TES T
DOO R TE S T
SEL F TE S T
HEAT ER TEST
PSM tHBT W CC = 2 1 0F
R1
R2
R3
R4
L1
L2
L3
L4
F
igure 22: Erase/Default Oven Settings
ERA S E COUNT E R S
AND FAULT LOGS
ERA S E SE T TINGS
COMPL E TE E R ASE
R1
R2
R3
R4
L1
L2
L3
L4