TurboChef ENCORE Service Manual

21
TEST MODE
Microwave Leakage Test
While in Manufacturing Mode (page 20), select
“MW Leak Test” to begin a microwave leakage test.
The oven will warm up to 500°F (260°C). When
warmup is complete, insert the water load and
follow the steps on page 26.
Microwave Power Test
Do not use - for manufacturer use only.
Burn In
While in Manufacturing Mode (page 20), select
“Burn In” to begin a 25-minute burn in. This
feature helps ensure the reliability of test results by
adequately warming the cavity walls. Burn in is not
usually required unless instructed by TurboChef.
Serial Number Edit
While in Manufacturing Mode (page 20), select
“Serial No. Edit” to edit the serial number (may be
required when replacing a control board).
To edit the serial number (Figure 30):
- Use the number/letter keys to change a
character. After one second, the cursor will
advance to the next character.
- Select “<” to move the cursor back.
- Select “>” to move the cursor forward.
- Select “Save” to save your changes or “Cancel”
to exit without saving.
Self Test
While in Manufacturing Mode (page 20), select
“Self Test” to access the oven self test screen.
From the Self Test screen (Figure 32):
- “Auto Test” will run all tests (listed below).
- “Door Test” will test the door switch sequence.
- “Blower Test” will increment the blower motor
speed to verify response at each setting.
- “Mag Test” will test magnetron operation.
- “Heater Test” will test heater operation.
When each test completes, the oven will display
PASS or FAIL.
Figure 27: Microwave Leakage Test
Figure 28: Burn In
Figure 29: Select “Serial Edit”
Figure 30: Serial Number Edit Screen
Figure 31: Select “Self Test”
Figure 32: Self Test Screen

TurboChef ENCORE Specifications

General

Brand	TurboChef
Model	ENCORE
Category	Oven
Language	English