Daily Cleaning for the Encore
tm
Oven
Follow the steps below when cleaning your Encore
tm
oven. Use only TurboChef ®-approved
cleaning chemicals. Failure to adhere to these procedures or the use of any other cleaning
products may damage critical oven components, resulting in a non-warranty service call.
TurboChef ® Oven Cleaner (Product Number: 103180), TurboChef ® Oven Guard
(Product Number: 103181), Kay ClickSan® sanitizer, nylon scrub pad, clean damp
and dry towels, disposable gloves, protective eyewear, dust mask (optional)
Step 6, Continued: Clean the Oven Cavity
DO NOT apply excessive pressure to the waveguide
covers (A), located on each side of the cavity.
• For stubborn stains, sparingly spray Oven Cleaner
on the stain.
• Allow the Oven Cleaner to penetrate the stain for ve
minutes, then wipe clean.
DO NOT use a hose or water jet for cleaning.
Step 8: Clean and Dry the Oven Door
• Clean the oven door with Oven Cleaner and a nylon
scrub pad.
• Wipe the oven door with a damp towel.
• Dry the oven door with a dry towel.
Step 10: Reinstall Components
• Reinstall the jetplate and the wire rack.
DO NOT operate the oven without the bottom
jetplate installed.
• Close the oven door.
• Reinstall the lter, or replace it with a new one if the
mesh is deteriorated, has large openings, or has started
to dislodge from the frame.
Part Number: DOC-1318 / Rev B / Oct 2011
Country Code: NA/EU
Customer Service: 800.90TURBO (within U.S.)
Customer Service: +1 214-379-6000 (outside U.S.)
©2011 TurboChef Technologies, Inc.
Step 2: Clean the Wire Rack
• e wire rack is held in place by tabs that are positioned
underneath either side of the jetplate.
• Lift the rear of the wire rack.
• Pull the wire rack forward until the tabs are free.
• Wash, rinse, sanitize, and dry the wire rack.
Step 1: Cool the Oven
WARNING: e oven operates at approximately 500°F
(260°C) and may cause injury if not allowed to cool properly.
• Turn o the oven by pressing the On/O key.
• Slightly open the oven door.
• Cooling takes approximately 30 minutes.
DO NOT proceed to Step 2 until the oven displays “ready
to clean.”
Step 3: Clean the Jetplate
• Lift the front of the jetplate.
• Pull the jetplate forward and remove it from the oven.
CAUTION: Handle the jetplate with care to avoid
chipping the porcelain coating.
• Wash, rinse, sanitize, and dry the jetplate.
DO NOT clean the jetplate with a wire brush.
Step 4: Clean the Air Filter
e lter must remain in place during oven operation, and it
must be cleaned regularly or replaced if damaged.
• Remove the air lter from the back of the oven.
• Rinse the air lter with hot water.
• Allow the air lter to dry completely.
Step 5: Remove Large Food Particles
• e heating element can be lifted for cleaning underneath.
DO NOT attempt to clean the heating element.
• Use a food vacuum or damp towel to remove large
particles from the oven cavity.
Step 9: Apply TurboChef
®
Oven Guard
• Spray TurboChef ® Oven Guard onto a dry towel.
• Wipe the cavity walls and the inside of the oven door.
DO NOT spray Oven Guard into the oven or apply to
the heating element.
Step 11: Clean the Oven Exterior
• Wipe the oven exterior with a damp towel.
• Remove the panel beneath the door, remove any large food
particles from the panel, and wipe it with a damp towel.
• Reinstall the panel beneath the door.
DO NOT spray chemicals into any openings, such as the
louvers on the side panels or the rear vent catalyst housing.
• e oven is ready to turn on.
Step 6: Clean the Oven Cavity
DO NOT spray TurboChef ® Oven Cleaner into the holes
in the oven cavity.
• Apply Oven Cleaner to a towel or nylon scrub pad
and clean the top, sides, and bottom of the cavity.
!
!
tm
Step 1 Step 6
Step 2 Step 7
Step 4 Step 9
Step 3 Step 8
Step 5 Step 10
Step 6 Step 11
Daily Cleaning Supplies and Equipment
A
Step 7: Wipe Down the Oven Cavity
• Wipe down the oven cavity with a damp towel.
• Dry the oven cavity with a dry towel.
Tab Location
To Next Page
