© 2011 TurboChef Technologies, Inc.
TM
Quarterly Cleaning for the Encore
TM
Oven
TURBOCHEF TECHNOLOGIES, INC.
To ensure optimal oven performance, complete the following cleaning steps once per quarter or more frequently as required.
Supplies and Equipment
Required: Phillips screwdriver, clean towels, rubber gloves for handling catalytic converter
Recommended: dust mask, vacuum, bristle or paint brush
Cleaning Steps
DOC-1343 / Rev A / Oct 2011
Country Code: NA/EU
1. Complete the daily cleaning
instructions (See DOC-1318 or
the owner’s manual).
CAUTION: Make sure the oven
is o before proceeding.
2. Remove the air lter.
3. Clean the cooling fans and
nger guards.
NOTE: A bristle or paint
brush and vacuum are
recommended for collecting
the debris.
4. Clean the louvers on both
side panels.
NOTE: A bristle or paint
brush and vacuum are
recommended for collecting
the debris.
5. Using a Phillips screwdriver,
remove the screws from the rear
vent catalyst housing. Support the
cover with your hand.
6. e catalytic converter is accordion style
and will pop out when the cover is
removed. Remove the cover slowly to
keep the catalytic converter in place.
CAUTION: DO NOT attempt to clean
the catalytic converter or spray chemicals
in this area.
7. Clean the housing:
- Hold the catalytic converter in place
with one hand.
- Using a clean towel, wipe out any
debris that has accumulated beneath
the catalytic converter.
- Clean the outer cover and make
sure the vent holes are not blocked.
8. Reattach the outer cover, making sure the
vent holes are at the bottom.
CAUTION: Installing the outer cover
upside down could result in excessive
grease buildup and/or hot steam present
when the oven door is opened.
10.Reinstall the air lter. e oven is
ready to turn on.
9. Wipe down the back panel with a
clean, damp towel.
To Previous Page
Loading...
Need help?
General