To change
the cook cavity temperature
(CCSP),
press
the UP and DOWN keys. Temperature ranges
vary depending on software.
Once you have selected
the correct
temperature, press the ENTER key to con-
firm and advance to the next screen
.
Altering a Recipe
Most NGC (Tornado) oven models contain 128
unique recipes. The display shows two (2) pages each
with eight (8) recipe groups. Each recipe group con-
tains eight (8) recipes. See Figures 11 and 12.
To alter a recipe:
1.
Enter the EDIT MODE (see page 16).
2. Enter the access code “9” and set the CCSP. The
screen displays the first set of eight (8) recipe
groups. To access the second set of eight (8)
recipe groups, press either the UP or DOWN key.
3.
Select the recipe group that contains the
individ-
ual recipe you wish to alter. Select the recipe you
wish to alter by pressing the soft key correspon-
ding to the recipe item. Figures 11 and 12.
4.
Use the
UP and DOWN keys to navigate through
the recipe settings. Use the keypad and ENTER key
to alter any of the following three (3) parameters
(see Figure 13):
a.
Cook
time
Total duration of the cook cycle. Enter the
desired time and press
ENTER.
b.
IR element temperature (IRSP)
The temperature the lower radiant element
will maintain during the entire cook cycle.
Valid temperatures are between 500
º
F (260
º
C)
and 1150
º
F (621
º
C).
c. Events 1…6
Use the keypad and
ENTER
key to enter values
for % TIME, % AIR, and % WAV.
o
Sum of %
TIME for all events must = 100.
The operating system will not allow a
combination of events not equal to 100%.
o
The % AIR parameter is valid between 10
and 100%.
o
The % WAV (microwave) parameter is valid
between 0 and 100%.
5. After making changes, test
the recipe by
pressing the TEST soft key. Once the oven has
warmed to the CC set point, press the TEST
soft key again to begin the test cook.
6. Once satisfied with the recipe, press SAVE to
permanently store changes.
7. Press the
BACK key until exited from EDIT MODE.
To Next Page
Loading...
Need help?
General