NOTICE:
This devic
e complies with P
art 18 of the FC
C Rules
.
Oper
ation is subject to the follo
wing conditions:
1. Thi
s devic
e may not cause harmful in
ter
fer
ence.
WARNING:
DHHS Feder
al Per
for
mance Standard 21 CFR 1030.
10.
To
provide continued protection against electrical
Pour assur
er pr
otec
tion con
tinue con
tre le cho
c
shock,
connect to properly gr
ounded outlets only.
AVE
RTI
SSEMENT:
correc
tem
ent mise a terre.
electr
ique branchez seulement a un
e prise
undesired opera
tion.
2.
This devic
e must acc
ept any in
ter
fer
ence
received
, i
ncluding in
terfer
ence tha
t may c
ause
Thi
s Ov
en complies with applic
able sections of
CONVECTION CIRCUIT/BLOWER MOTOR PARTS
Figure 38
102.
101688 Screw, #8 x 1/2” PTH
103.
NGC-1081
Cover, Motor
104.
100906
Nut, 1/4”-20, Flange
105. NGC-1025 Assy, Blower Motor
106. NGC-3007 Kit, Fan Blade
107.
NGC-1024 Sealing Block, Blower
108.
NGC-1023
Clamp, Blower Seal
109. 101688 Screw, #8 x 1/2” PTH
110. NGC-3011 Heater, Convection
111. 100443 Controller, Motor
112. NGC-3005 Relay, K4/K5 SSR
113.
100592 Fuses, F1 and F2 (12 Amp)
114.
102075
High-Limit Thermostat
115. NGC-1043 Gasket, Convection Heater
* If entire motor is needed, order NGC-1025.
If only hardware (e.g., screws, nuts) or seal is
needed, call 800.90
TURBO or +1 214-379-6000.
** Not shown for clarity.
Assembly Notes
1. Cut insulation covering heater as shown.
FIGURE 38: Convection Circuit Assembly and Parts/Item 105 (Blower Motor) Detail
*
**
111
x6
113
112
102
103
104
105
109
110
114
x8
x10
1
1
THE CONVECTION CIRCUIT
48
106
108
107
*
*
To Next Page
Loading...
Need help?
General
