turbofan E23D3 Service Manual

Service Parameters
29
Turbofan E20D Series Convection Ovens © Copyright Moffat Ltd. 10 February 2016.
Amendment 1
Viewing / Changing Service Parameters
NOTE: Oven must be in ‘Stand-By’ Mode to access Service Parameter settings (i.e. Power to oven but both displays are blank and
‘On/Off’ LED is ‘On’).
1. ENTER SERVICE PARAMETER MODE.
Press and hold 'Steam' and ‘Timer-Start/Stop’ keys together for 3 seconds.
Left Display will show .
Right Display will flash .
2. SET PASSWORD (SERVICE / FACTORY PASSWORD - 321).
Rotate ‘Timer’ knob to enter Service Password .
Press ‘Light’ key to confirm password.
Left Display will show one of the operator settings, eg.
Right Display will show the value of the setting, eg.
3. SETTING THE PARAMETERS
.
Rotate ‘Timer’ knob to the parameter required.
Press ‘Light’ key to confirm parameter. Right Display will flash.
Whilst Right Display is flashing, rotate ‘Timer’ knob to select value required.
Press ‘Light’ key to confirm value. Right Display will stop flashing.
See overleaf for a list of Operator Settings available
4. EXITING THE PARAMETER MODE.
Press ‘On-Off’ key, to exit the Parameter Settings Mode and to return to Stand-By Mode.

turbofan E23D3 Specifications

General

Brand	turbofan
Model	E23D3
Category	Oven
Language	English