turbofan E23D3 User Manual

Operation
12
Cooking in Program Mode (Continued)
Viewing / Adjusting Temperature During Program Cooking.
 VIEWING ACTUAL OVEN TEMPERATURE
Press ‘Temp’ key during cooking. Oven Set Temperature will display on Left Display for 2 seconds, then Actual Temperature
will display on Left Display for 2 seconds. Display will revert to displaying the program number after 4 seconds.
 VIEWING SET TEMPERATURE
Turn ‘Temp’ knob (in either direction) to display Set
Temperature of Current Stage on Left Display. Display will
revert to displaying the current program number after a
5-second delay.
 ADJUSTING SET TEMPERATURE
Hold ‘Temp’ knob in either direction for 3 seconds to enter
‘Temp Edit Mode’ where ‘Temp’ knob can be used to
temporarily adjust temperature for the current stage.
Controller will update the Temperature and exit ‘Temp Edit
Mode’ after a 5-second delay.
Viewing / Adjusting Time During Program Cooking.
 VIEWING STAGE NUMBER AND REMAINING TIME
Turn ‘Timer’ knob (in either direction), or press ‘Program’ Key
to display Current Stage-in-Progress (Stage, Stage Time
Remaining). Displays will revert to displaying program
number and time after a 5-second delay.
 ADJUSTING REMAINING TIME
Hold the ‘Timer’ knob in either direction for 3 seconds to enter
‘Timer Edit Mode’ where ‘Timer’ knob can be used for
temporary adjustment of Stage Time remaining.
The controller will update the value and exit ‘Timer Edit Mode’
after a 5-second delay.
Time remaining can be adjusted between 0-180 minutes, but cannot be set to ‘InF’.
 ADDING MORE TIME TO A STAGE WHEN THE END OF STAGE ALARM IS SOUNDING.
At the end of a stage, provided that ‘ALr’=On, an end of stage alarm will sound for 1 minute before automatically progressing on to the
next stage of the program. While alarm is sounding, additional cooking time can be added to the stage if required.
Rotate and hold ‘Timer’ knob for 3 seconds to enter Timer Edit Mode and add time to the stage.
When the additional length of time required is displayed.
Press ‘Timer-Start/Stop’ key to resume the stage,
NOTE: Any changes will only apply to the current stage. Following stages will revert to the programmed settings. Changes made
to a program while it is running will not be saved.
Here Oven Set Temperature has been increased from 150 to 175°C
(325 to 350°F).
Here Time has been increased from 54 minutes to 75 minutes.

turbofan E23D3 Specifications

General

Brand	turbofan
Model	E23D3
Category	Oven
Language	English