33
22 • SELF-DIAGNOSIS AND ERROR GUIDE
22.1
•
When the oven is turned on via the main
switch, an electronic check of the main
functions will automatically be performed.
Once the self-diagnosis has been
performed, if the oven proves to be in
perfect operating conditions, the cooking
chamber temperature display will show
the real temperature of the chamber and
the cooking mode leds will flash. Cooking
parameters can therefore be set.
22.2
•
If on the other hand the oven detects
errors, these will be shown on display 7.
The visualisation of errors is very important
in the event technical support is required,
as this value provides information about
the type of error. The message on the
display is accompanied by an acoustic
signal that lasts for 5 seconds, which is
repeated every minute until the oven is
turned off.
ERROR MESSAGE
“ E10 ”
Shown on display 7. Fault in cooking chamber
temperature probe, immediately turn off the oven and
call the technical support service.
The main error messages are:
“ E12 ”
Fault in vapour condensation temperature probe. The
oven can be used under careful observation (increased
water consumption), until the technical support service
intervenes.
“ E13 ”
Fault in core probe. The oven may be used in timed
mode until the technical support service intervenes, but
without the use of the core probe.
“ A 4 ”
This means that no water is reaching the oven; it is
therefore necessary to check that the tap is open and that
there is water in the network. If the lack of water depends
on the network, inform the supplying entity. If on the other
hand there is water in the network, call the technical
support service. In the meantime, the oven can be used in
convection mode.
E 10
E 12
E 13
A 4
240066-1
To Next Page
Loading...
Need help?
General
