22
Maintenance
Troubleshooting
Below is the information you need to perform proper maintenance on your EV700:
General Issues
• The are no parts within your EV700 that the user has to maintain. Only a qualified electrician may open and
modify your EV700.
• Always make sure that the power supply is turned off before you start cleaning your EV700.
• If you want to clean your EV700 we recommend that you use a soft, dry or damp cloth. Do not use a spray
or direct water stream to clean your EV700 charger.
• Never try to open your EV700. Contact TurnOnGreen for any issues. The use of any other tool or means may
cause damage in the charger, which wouldn’t be covered by the product warranty.
Charger does not power up
This could mean that there is no current reaching the EV700. The circuit breaker could be off or has
tripped. Please check the circuit breaker and make sure that it is working. Press the test button on the
circuit breaker - it should disconnect itself.
Charging session did not start
The reasons could be any of the following:
• The vehicle is scheduled for a later time.
• The vehicle is completely charged.
• The vehicle may be causing the error. Check the vehicle.
• The charging plug is not connected properly, reconnect the plug.
• The charging plug may be dirty or damaged, ensure that it is in good condition.
The vehicle has not charged completely, the charging time is greater than normal
or the vehicle only charges at a low power
When the vehicle’s charging session is almost complete, the charging speed begins to fall.
On the other hand, if the charger or the vehicle detects a temperature that is too high, the charging
power is reduced for safety.
To Next Page
Loading...