TV One C2-7300 - Page 41

150 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

34

terminal blocks

A3-7342

Break-out and conversion of 4xIN & 4xOUT to analog audio on XLR

connectors

Note: in all cases, a DARS input is also available on a BNC connector.

Since there are 2 AES3-id I/O connectors on the rear of the C2-7300 & C2-

7310 unit, you can mix and match up to 2 of the above A2-7300 series units.

Table of Contents

Default Chapter3
- Table of Contents3
1 Disclaimer8
- Regulatory Agency Acceptance8
- FCC Statement9
2 Important Safety Instructions10
3 Capability, Terms of Reference and Overview Summary20
- Device Capabilities20
- Terms of Reference21
- Device Overview22
- Models Available23
- Input Sources24
- Outputs24
- Windows24
- Layers25
- Modes26
- Switcher Mode26
- Independent Mode27
- Dual PIP Mode28
4 Unpacking and Installation29
- Shipping Carton29
- Furnished Accessories29
5 Functional Check30
- Important Safety Instructions30
- Factory Reset31
- Initial Operation Check Using Factory Default Settings31
6 Controls and Connections33
- 10-Button Programmable Panel33
- 48-Button Non-Programmable Panel35
- Inputs and Outputs37
7 Audio Inputs and Outputs39
- Connection Summary39
- DARS Locking39
- Audio Outputs in Different Modes40
- Options Available40
8 Changing the Operating Mode42
- Operating the Unit as a Video Switcher42
- Switching an Input43
- Operating the Unit as Two Independent Processors43
- Selecting Inputs to the Windows43
- Operating the Unit in Picture in Picture Mode (Dual PIP)44
- Selecting Inputs for the Individual Windows44
9 Menu Topography and Adjustment Methodology46
- The High Level Menu Structure47
- Advanced Menus48
- Group Names and Descriptions48
- Items Associated with the Device Mode Group48
- Items Associated with the Adjust Outputs Group48
- Items Associated with the Adjust Windows Group52
- Extended Scaling Controls56
- Aspect Adjust' = 'Advanced57
- Aspect Adjust' = 'Pixel58
- Items Associated with the Adjust Keyers Group58
- Edge Blend Items Within the Adjust Keyers Group60
- Items Associated with the Adjust Logos Group61
- Items Associated with the Adjust Borders Group62
- Items Associated with the Adjust Sources Group63
- Menu Items Common to All Inputs64
- DVI Source Menu Items67
- RGB Source Menu Items69
- CV & YC Source Menu Items70
- Still Image Store / Testcard Source Menu Items70
- Items Associated with the Adjust Audio Group + Other Digital Audio Adjustments71
- Extra Item in Adjust Outputs73
- Extra Item in Adjust Windows73
- Extra Item in Adjust Sources74
- Adjust Audio74
- Items Associated with the Adjust Transitions Group75
- Items Associated with the Adjust Buttons Group76
- Items Associated with the Adjust Ethernet Group77
- Items Associated with the Adjust Resolutions Group79
- Items Associated with the System Group82
10 Serial Port86
- Connection86
- Communications Protocol86
11 Serial / Ip Control Specification88
- Communication Protocol Basics88
- Packet Format89
- Function List91
- Examples99
- Reading and Writing Macros100
- Reading a Previously Stored Macro101
- Writing to a Macro101
- Run and Restore Macros102
- Emulate a Front Panel Button Press102
- Reset Command107
12 Common Operations108
- Operation of the Keyer108
- Creating a Macro113
- Standards Conversion - NTSC to PAL114
13 Edge-Blending Setup115
- Introduction115
- Edge-Blending Requirements116
- Basic Setup of the Two Projectors117
- Connections to the Scaler(S) and Projectors117
- Initial Setup118
- Edge-Blending Activation119
- Edge-Blending Overlap / Size119
- Edge-Blending Guide Lines120
- Alignment of Projectors121
- Gamma Correction123
- Brightness Compensation123
- Aspect Ratio Adjustment124
- Locking both Outputs Together124
- Other Setup Approaches125
14 Windows Control Panel127
- Opening Screens127
- Selecting a Serial Port Connection127
- Selecting an Ethernet Connection127
- Connecting to a Unit128
- Application Menu's130
- File Menu130
- Communications Menu130
- Tools Menu131
- Resolution Menu131
- Scripting Tool131
- Image Loader132
- Loading Still Images / Testcards133
- Loading Logos134
- Maximum Image Size - How Large Can My Logo / Still Image / Testcard be135
- Resolution Editor135
15 Troubleshooting and Technical Support139
- There Is no Picture on the Output139
- The Image Is Shifted and Not Fully Viewable139
- The Output Resolutions no Longer Appear as Expected139
- There Is Excessive Flicker on the Output140
- The Output Image Is Distorted140
- Some Colors Appear to be Incorrect on the CV/YC Output140
- How Can I Reduce Color Smearing on CV Connections140
- I Can no Longer Adjust the Output Image Resolution140
- The Picture on the Video Display Is Black and White140
- The Picture on the Video Display Is Green140
- The RGB Input Is Selected but the Image Is Rolling or Pink141
- The Video Signal from My DVD Player Does Not Appear to Work141
- Image Is Flashing, Snow Is Present, or Source Image Does Not Appear141
16 Return Procedure142
- Are You Sure There's a Fault142
- To Return a Unit for Repair142
17 Warranty Policy144
18 Connector Pinouts145
- DVI-I Connector145
- RS232 / DB9 Connector145
- Pin Mini-DIN S-Video Connector (YC) Input145
19 Specification146
- Video Inputs146
- Genlock Input146
- Independent Output 1146
- Independent Output 2146
- Input/Output Range146
- Input RGB Sync147
- Output RGB Sync147
- SDI/HD-SDI Embedded Audio & Ancillary Data (C2-7200/7210/7260 Only)147
- SDI/HD-SDI Embedded Audio (C2-7300, C2-7310 Only)147
- AES3-ID Inputs & Outputs(C2-7300, C2-7310 Only)147
- Audio Switching (Optional A2-2000)147
- Control Methods147
- Mechanical148
- Environmental148
20 Contact Information149

Related product manuals

Preview: TV One C2-7100

Preview: TV One 1T-C2-750

TV One 1T-C2-750

Preview: TV One 1T-C2-100

TV One 1T-C2-100

Preview: TV One C2-2000A Series

TV One C2-2000A Series

Preview: TV One 1T-AP-216

TV One 1T-AP-216

Preview: TV One 1T-VS-624

TV One 1T-VS-624

TV One 1T-VGA-DVI

Preview: TV One 1T-FC-766

TV One 1T-FC-766

Preview: TV One 1T-FC-425

TV One 1T-FC-425

TV One 1T-DVI-VGA

Preview: TV One 1T-VS-622

TV One 1T-VS-622

TV One 1T-VS-647