TV One C2-7300 - Page 5

C2-7000 SERIES OPERATION MANUAL
10.1 Connection........................................................................................................79
10.2 Communications protocol ..................................................................................79
11.0 SERIAL / IP CONTROL SPECIFICATION...............................................81
11.1 Communication protocol basics.........................................................................81
11.2 Packet format ....................................................................................................82
11.3 Function list.......................................................................................................84
11.4 Examples...........................................................................................................92
11.5 Reading and writing macros ..............................................................................93
11.5.1 Reading a previously stored Macro....................................................................94
11.5.2 Writing to a macro..............................................................................................94
11.5.3 Run and Restore macros...................................................................................95
11.5.4 Emulate a front panel button press ....................................................................95
11.5.5 Reset command ..............................................................................................100
12.0 COMMON OPERATIONS......................................................................101
12.1 Operation of the Keyer.....................................................................................101
12.2 Creating a Macro.............................................................................................106
12.3 Standards Conversion – NTSC to PAL ............................................................107
13.0 EDGE-BLENDING SETUP....................................................................108
13.1 Introduction......................................................................................................108
13.2 Edge-blending requirements............................................................................109
13.3 Basic setup of the two projectors.....................................................................110
13.4 Connections to the scaler(s) and projectors.....................................................110
13.5 Initial setup......................................................................................................111
13.6 Edge-blending activation..................................................................................112
13.7 Edge-blending overlap / size............................................................................112
13.8 Edge-blending guide lines................................................................................113
13.9 Alignment of projectors....................................................................................114
13.10 Gamma correction...........................................................................................116
13.11 Brightness compensation.................................................................................116
13.12 Aspect ratio adjustment...................................................................................117
13.13 Locking both outputs together..........................................................................117
13.14 Other setup approaches..................................................................................118
14.0 WINDOWS CONTROL PANEL ............................................................. 120
14.1 Opening screens .............................................................................................120
14.1.1 Selecting a serial port connection....................................................................120
14.1.2 Selecting an Ethernet connection ....................................................................120
14.2 Connecting to a unit.........................................................................................121