high beam position. This is to put the driving
beam while zipping on high ways.
4. Turn signal switch
Sliding type switch is provided for operating
turn signal lamp. Pushing the switch to any
one side will operate the corresponding turn
signal indication and the switch comes back
to middle. Pressing in the switch in this
position will put off the indication.
5. Horn switch
Press switch to operate the horn.
6. Choke lever
Choke lever is given below the horn switch.
Pull choke lever using left thumb to open the
choke. To close the choke just release the
corresponding turn signal indicator lamp will
flash.
1. Rear brake lever
Rear brake is applied while pressing brake
lever gently towards the grip LH. Brake lamp
will glow on the application of rear brake.
KNOW ABOUT YOUR TVS DAZZ
HANDLE BAR LEFT SIDE
13
To Next Page
Loading...
