Tyco P5400 series - Sending an Individual Call; Figure 8-11: Calls Received Lists; Figure 8-12: WHC Individual Call Display

To Next Page

To Previous Page

MM-012099-001

Figure 8-11: Calls Received Lists

To access the Calls Received List, press the

key twice. Use the or buttons to scroll through

the list. Pressing the

key will display the time elapsed since the call was received. After pressing

the display will appear similar to Figure 8-12.

Figure 8-12: WHC Individual Call Display

Pressing the PTT will initiate an individual call to the displayed logical ID. Powering the radio OFF and

ON will clear this list.

8.22.2 Sending an Individual Call

8.22.2.1 Pre-Stored Individual Calls

The following procedures describe how to initiate and complete a Pre-Stored Individual Call.

P5470 Model Radio

1. To select a pre-stored individual phone number, enter the individual call mode using the

key. is

displayed. Then scroll through the list of stored numbers using the

or keys.

2. Press the PTT button; when the radio is clear to transmit,

turns ON, turns OFF and the channel

access tone sounds. Line one shows the called individual's name if found in the list of stored

individuals or LID followed by the logical ID number of the unit being called. The message *INDV*

displays on line two.

P5450 Model Radio

1. To select a pre-stored individual number, enter the menu mode by pressing the

key. Scroll

through the mode list using the

or buttons.

2. Press

. is displayed. Scroll through the list of stored phone numbers using the or

buttons until the desired number is displayed. Press .