14
3. Turn on PTO (power take off).
CAUTION
Ensure that the moving floor is set to neutral. The floor
will start to move as soon as the power take off (PTO) is
engaged.
4. Open the rear doors (Figure 05 - 2). (Refer to Option: Barn
Doors on page 31), (Refer to Option: Top Hinge Door
on page 33) Or (Refer to Option: Combo Door on page
35)
Figure 05 - 2
DANGER
Depending on the material being hauled, the load can
potentially settle and put extreme pressure on the rear
doors. Use caution, as the door may burst open when
opening.
Unload payload using the supplied moving floor (Figure 06 - 2).
(Refer to Option: Moving Floor by Keith® on page 27)
Figure 06 - 2
5. Close and secure the rear doors (Figure 07 - 2). (Refer to
Option: Barn Doors on page 31), (Refer to Option: Top
Hinge Door on page 33) Or (Refer to Option: Combo
Door on page 35)
Figure 07 - 2
6. Close the tarp. (Refer to Option: Manual Roll Tarp on page
17) Or (Refer to Option: Flip-Top Tarp on page 21)
7. Inflate trailer suspension by turning the air spring valve
(Figure 08 - 2). The valve is located on the driver side,
along the bottom edge in front of the first axle (Figure 09
- 2).
Figure 08 - 2
Figure 09 - 2
8. Perform a pre-trip inspection.
Loading and Unloading Operation - 2
To Next Page
Loading...