Operator’s Manual | Moving Floor Trailer 37
Option: Clean Out Wall - 11
Option: Clean Out
Wall
The following information will help ensure that your Cleanout
Wall operates as effectively as possible. Below are the set-up
and operational instructions for drivers using the Cleanout
Wall, as well as some information about different kinds
of products and how their properties will affect the wall’s
performance.
Cleanout Wall Set-Up and Use
Prior to Loading
1. Once the trailer is unloaded throw the tarp back in the
trailer, give the wall a push so that you have enough
room to safely climb into the trailer.
2. Push the Cleanout Wall to the front wall of the trailer
(Figure 01 - 11). Either hang the tarp on the hooks or
pick up the tarp so it is not under foot while moving the
wall. The chain restraints will be behind the wall when
you get to the front of the trailer; use the hook stored on
the driver’s side of the wall, under the rubber flap to pull
the chain out from behind the wall.
Figure 01 - 11
3. When the wall is all the way forward and the chains
have been retrieved, clip the lower Crosby latch into
the corresponding eye hook on each side, to secure
the Cleanout Wall in place. This will keep the wall from
moving around while in transit, preventing possible
damage to the wall or the trailer, and will ensure the
wall is at the front of the trailer when you arrive at your
destination.
4. Make sure the tarp is evenly spread out across the floor
of the trailer and is not bunched up against the wall
or folded on itself (Figure 02 - 11); this will ensure the
Cleanout Wall functions optimally.
Figure 02 - 11
5. Once you arrive at your destination you will need to go
into the trailer to unclip the restraints, at the same time
you can recheck the tarp is laid out correctly.
6. IMPORTANT: If you do not intend to use the wall with
a particular load make sure you hang the tarp on the
hooks and it is tucked under the rubber flap so product
doesn’t get into the tarp while you are loading.
7. IMPORTANT: If you are unloading at a tipper do not
unfasten the chain restraints (Figure 03 - 11); the
restraints will prevent the wall from sliding very rapidly to
the back of the trailer, and possibly damaging the trailer
or the wall.
Figure 03 - 11
Operational Instructions
1. While you are on your way back to unlock and open the
rear door(s) undo all of the tarp securement, bungees
and cinches or ratchets. This will prevent the tarp from
restraining the load while the wall is pulling forward.
Figure 04 - 11
To Next Page
Loading...