① High beam lamp is operated on the combination switch.
② Low beam lamp is operated on the combination switch
③ PTO Monitor Lamp
This lamp will turn on when PTO clutch is engaged.
④ Cruise Control Lamp
This lamp will turn on when cruise control is engaged.
⑥ Fuel Empty Warning Lamp
This lamp shows warning that the fuel in fuel tank goes empty. If this
lamp comes on, Fill the tank with fuel.
⑦ Oil pressure lamp
correct. If it comes on while the engine is running, stop the engine and get
expert advice.
⑧ Charge lamp
This lamp will go off as soon as the engine starts to run to indicate that
the alternator is charging (Please note, as broken fan belt can cause the
light to come on, please stop the engine as overheating can occur if not
rectified immediately).
⑨ Glow signal Lamp
This lamp indicates pre-heating.
⑩ Turn Signal Lamp
These lamps are used to indicate operator’s turn direction.
When indicator is pulled down, left turn signal turns ON and flashes.
When indicator is pushed up, right turn signal turns ON and flashes.
These lamps will turn on and flash when hazard waning switch is pushed.
To Next Page
Loading...
Need help?
General
