,Be sure to wind the wire paying sufficient
attention to its winding direction and bend
the lock washer for secure looking.
4) When locking bolts and nuts with an
adhesive,apply the adhesive on the thread
and tighten securely.
5) Apply an adhesive(THREE BOND
TB1104) to parts through which there is
any possibility of oil leaks,such as stud
bolts and tapped-through parts.
6) Each lock nut must be tightened securely.
7) When tightening bolts and nuts, refer to
the tightening torque table.
(8) After installation, each grease fitting
should be filled with grease.
1) When installing grease fittings of type B
and C,be sure to turn the fitting tips in a
direction that will provide easy access for
a grease gun.
4) Each contact surface should be coated with an
adhesive (THREE BOND TB 1215) and
tightened evenly with bolts.
Adhesive coated surfaces should be installed
within 30 minutes after application of the
adhesive.
The contact surfaces should be flawless and free
from foreign matter,and especially from grease
before application of the adhesive.
5) Precautions for applying adhesives.
- The surface or the thread where and adhesive is
to applied should be completely free of chips.
- The surface or the thread where an adhesive is to
be applied should be completely free of oil-ness.
(9) Other precautions
1) Be sure not to damage any finished
surfaces or parts.
2) Always refrain from forcing installation.
3) Each lever knob should be installed coated
with an adhesive (SUPER THREE
CEMENT TB1702)
2-3
To Next Page
Loading...
Need help?
General
