TypeS 1253313 - Troubleshooting

16
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626 | Tel: 866-294-9244
© 2018 Winplus North America Inc. All Rights Reserved.
Issue Cause Remedy
Cannot jump
start
Wrong clamp
connection
Make sure to clamp the RED jumper cable to
the POSITIVE (+) post on the car battery. And
BLACK jumper cable to NEGATIVE (-) post or
car interior. Refer to Page 6 for details.
90-Second timer to
jump start has expired.
Jump starter timed out. Disconnect the cables
from the vehicle battery and reconnect.
Low battery status Recharge the unit via USB cable until at least
three solid lights or 51% charge.
Battery voltage of
vehicle battery too low
Replace vehicle battery. The jump starter will
not be able to jump start the vehicle.
LED light on the
clamp box keeps
ashing
Protection circuit is
working
Refer to the status table on the indicator box
or page 9 of the manual.
Flashlight does
not turn on
Low battery Recharge the unit via USB cable.
The unit is charging As a safety precaution, the ashlight light will
not work while the unit is charging. Please
unplug the unit from charging or wait until the
unit nishes charging before using the light.
No wall adaptor Charge via USB cable Plug the USB cable into computer or any USB
2A wall adaptor.
No LED indicator
light
Low battery Refer to Power level indicator on page 4 of
the manual.
Power bank in off
mode
Press the power on/off.
TROUBLESHOOTING:
ML-56789_V3
Have a comment or question? Email us at: info@typesauto.com
or visit us online at www.typesauto.com
WARNING: This Jump Start is only intended to jump start 12V cars, trucks, boats, or
motorcycles with an internal combustion engine and single lead-acid battery systems.
Do not use this device to jump start batteries outside of these four types of vehicles;
doing so may cause a re or other serious injuries. Refer to the user manual for
additional safety information.