9
JUMP STARTING CONT.:
Polarity Protection Circuit Status
Solid LED On Flashing LED LED Off
Status (Light & Sound Indicator)
Status Meaning:
Red Light Green Light Sound
None The car battery is ready to jump start.
None The car battery is ready to jump start. If
the indicator doesn’t turn solid Green, the
car battery voltage is higher than the jump
starter. You can still jump start your battery,
but may need to charge your jump starter.
None The Jump Starter needs to be charged. Plug
the unit into a micro USB cord and either a
wall adapter or the included car adapter to
charge.
Beeping Disconnect the jumper cable from the car
battery and jump starter. Either the car jump
start is complete or there is a connection
problem.
None This status shows after 90 seconds time out.
Disconnect the jumper cable from the car
battery and jump starter to reset. Reconnect
the jumper cable to jump start the vehicle.
None Please contact Winplus for troubleshooting.
LED Light
Flashlight Press and hold the power button for three
seconds.
Strobe Light Press once while in ashlight mode
Hazard Light Press once while in strobe light mode
Turn Off Press and hold the power button for three
seconds.
To Next Page
Loading...
