12
User’s Manual
12
3. For recessed installations,
allow extra water supply line
length to provide slack for easy
removal from the recessed
area (see Figure 9). This will
also safeguard against kinking
the line.
Figure 9
CAUTION
If you are not intending to use
the ice maker and do not con-
nect the water supply (or turn
the supply valve off), it is
imperative to raise the bucket
arm of the ice maker (see
Figure 10). Failure to raise the
bucket arm may result in
damage to the water valve.
Figure 10
NOTE
After completing the installation, turn on the water and
recheck water connection for leaks. Apply additional tighten-
ing if needed. Do not use thread sealing compound or tape.
4. Plug in the power cord.
5. Gently push the unit into position to prepare for built-in installation.
To Next Page
Loading...
