Ubee Interactive Using the LAN Options
Ubee UBC1303AB00 Advanced Wireless Voice Gateway Subscriber User Guide • June 2017 43
6.2.1.1 Adding DHCP IP Lease Reservations
After clicking the Add Entries button on the DHCPv4 screen, the following screen appears
and allows you to add the MAC and IP Addresses for the new lease. Click Apply when
once information has been added.
After clicking apply, the information appears in the orange table on the DHCPv4 screen
(see below).
Start IP Address
Defines the starting IP address for the pool of IP addresses that can be used by
connecting clients.
End IP Address
Defines the ending IP address for the pool of IP addresses that can be used by
connecting clients.
Lease Time
Defines the DHCP lease time duration in minutes between 1 and 71582788. A DHCP
user's PC gets an IP address with a lease time. When the lease time expires, the PC
must connect to the DHCP server and be issued a new unused IP address.
Note: The default DHCP lease time is 3600 seconds and should be changed to
86400 seconds (24 hours). This helps resolve connectivity issues with some iMAC
and Windows 7 devices that turn off the network interface when they go into standby
mode. This results in slow Web browsing until the device gets a new IP address via
DHCP.
Add Entries
Click the Add Entries button to add DHCP IPv4 Address Lease Reservations. Adding
DHCP IP Lease Reservations on page 43 below for more detail.
Enable DHCP Server
Relay
Check the box to enable a host that forwards DHCP packets between clients and
servers.
DHCP Server IP
Address
Allows you to enter the IP Address for the DHCP Server Relay host.
MTU Size
Allows you to enter the maximum transmission unit (MTU) size. MTU defines the
largest size of the packet or frame that the device can transfer (256-1500). If this is
not given by your service provider, use 0 for the default.
Apply/Save Saves all changes.
Label Description
To Next Page
Loading...
Need help?
General
