3. A pop-up screen will appear asking for your Uconnect
Security PIN (this is the same 4- digit code established
when your registered your Uconnect Access system).
Enter the Uconnect Security PIN on the keypad and
press “OK.”
4. The Uconnect Access App will confirm if your com-
mand was sent (or not). Press “OK” to close the
pop-up screen.
5. It will take a little while for the command to go
through to your vehicle. The time it takes depends on
a number of technical conditions.
6. A message will appear on the screen to let you know
if the command was received by your vehicle.
Mopar Owner Connect website:
1. Log on to the Mopar Owner Connect website
(
moparownerconnect.com
) using the username and
password you used when registering your Uconnect
Access system.
• If you forgot your username or password, links are
provided on the website to help you retrieve them.
2. If you have more than one vehicle registered into the
Mopar Owner Connect website
(
moparownerconnect.com
), select the vehicle you
want to send the command by clicking on its image
along the top.
3
ALL ABOUT UCONNECT ACCESS 65
To Next Page
Loading...