8
Page.
/ 8
Reassembly
18. Secure with the clamp clip
• Place the blue clamp clip around the tube coupling collet to secure
the Bowden tube.
19. Divide the clips
• Evenly divide the clips over the Bowden tube and braided sleeve.
• Make sure to keep the braided sleeve on the left of the Bowden
tube.
Tip: Check if the print head is moving smoothly in both directions. If
not, the print head shafts may not be in a 90º angle anymore. In this
case it is recommended to calibrate the print head using the print
head alignment tools.
For internal use only
To Previous Page
Loading...
