Need help?Do you have a question about the Ultimaker 3 Extended and is the answer not in the manual?
General| Build Volume | 215 x 215 x 300 mm |
|---|---|
| Layer Resolution | 20 - 200 microns |
| Print Technology | Fused Filament Fabrication (FFF) |
| Filament Diameter | 2.85 mm |
| Operating System | Windows, MacOS, Linux |
| Print Speed | Up to 24 mm³/s |
| Software | Ultimaker Cura |
| Weight | 11.3 kg |
| Print Head | Dual extrusion |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, Nylon, CPE, PVA |
| Connectivity | USB, Ethernet, Wi-Fi |
| Display | 4.7" color touchscreen |
| Power Requirements | 100 - 240 V / 50 - 60 Hz |
| Travel Speed | Up to 300 mm/s |
Provides essential warnings and guidance for safe operation and to prevent injury.
Outlines potential risks including electrical, mechanical, burn, and health hazards.
Guides the user through inserting and recognizing the printer's print cores.
Explains how to load filament spools into the printer feeders.
Details connecting the printer to a network and updating its operating software.
Guides on using Cura software to slice models for printing.
Instructions for initiating prints via network or USB.
Guides for build plate leveling, Z offset, and XY offset adjustments for print accuracy.
A comprehensive list of error codes and links to their specific troubleshooting guides.
To Next Page
