Need help?Do you have a question about the Ultimaker 2 Go and is the answer not in the manual?
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Filament Diameter | 2.85 mm |
| Connectivity | USB, SD card |
| Print Technology | Fused Filament Fabrication (FFF) |
| Feeder Type | Bowden |
| Display | LCD |
| Build Volume | 120 x 120 x 115 mm |
| Layer Resolution | 200 microns |
| Compatible Materials | PLA |
| Print Speed | 30 mm/s |
| Power Input | 100 - 240 V |
Warning about user responsibility and liability for device use.
Specifies the printer's design purpose and supported materials.
Visual guide to the printer's components and features.
Technical details of print technology, dimensions, electrical, and temperature.
Step-by-step guide for unpacking the Ultimaker 2 Go.
List and identification of all items included in the package.
Instructions for installing the spool holder and glass plate.
Guide on how to connect the power supply correctly.
Navigating the printer interface and initial setup.
Procedure for loading filament into the printer.
Instructions on how to select and start a print job.
How to unload old and load new filament.
Steps to calibrate the build plate for optimal first layers.
Installation, usage, and firmware updates for Cura software.
Understanding the main menu, print, material, and maintenance options.
How to replace the blue tape on the glass print bed.
Adjusting feeder tension and cleaning the mechanism.
How to lubricate the X, Y, and Z axes for smooth operation.
Procedure to clean the nozzle and hot end to resolve extrusion issues.
Solutions for extrusion problems, connection errors, and print adhesion.
Explanations and causes for various error messages.
Information on website support and local partners.
EMC, electrical, mechanical safety, burn risks, and health considerations.
Precautions for users, children, and general handling.
To Next Page
