Need help?Do you have a question about the Ultimaker 2 Extended and is the answer not in the manual?
Step-by-step guide to unpack the Ultimaker 2 Extended from its packaging.
Instructions for attaching the spool holder and installing the glass build plate.
Guide to navigating the display and performing bed leveling for initial setup.
Step-by-step guide for loading filament into the material feeder and print head.
Instructions on selecting print files, preparing the printer, and starting the first print.
Addresses extrusion, connectivity, and print adhesion problems, plus error messages.
Step-by-step guide to unpack the Ultimaker 2 Extended from its packaging.
Instructions for attaching the spool holder and installing the glass build plate.
Guide to navigating the display and performing bed leveling for initial setup.
Step-by-step guide for loading filament into the material feeder and print head.
Instructions on selecting print files, preparing the printer, and starting the first print.
Addresses extrusion, connectivity, and print adhesion problems, plus error messages.
General| Build Volume | 223 x 223 x 305 mm |
|---|---|
| Layer Resolution | 20 - 200 microns |
| Filament Diameter | 2.85 mm |
| Connectivity | USB, SD card |
| Print Technology | Fused Filament Fabrication (FFF) |
| Print Speed | 30 - 300 mm/s |
| Software | Cura |
| Print Head | Single |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, CPE |
| Display | LCD |
| Power Requirements | 100-240 V, 50/60 Hz |
To Next Page
