Need help?Do you have a question about the Ultimaker S3 and is the answer not in the manual?
General| Build Volume | 230 x 190 x 200 mm |
|---|---|
| Print Technology | Fused Filament Fabrication (FFF) |
| Filament Diameter | 2.85 mm |
| Number of Print Heads | 2 |
| Print Speed | Up to 24 mm³/s |
| Heated Bed | Yes |
| Dual Extrusion | Yes |
| Operating Temperature | 15 - 32 °C |
| Nozzle Diameter | 0.4 mm |
| Connectivity | Wi-Fi, USB, Ethernet |
| Supported Materials | PLA, ABS, Nylon, CPE, PC, TPU, PP, PVA, Breakaway |
| Touchscreen | Yes |
| Feeder Type | Dual-geared feeder |
| Build Plate | Glass |
| Bed Leveling | Automatic |
| Power Requirements | 100-240 V, 50-60 Hz |
| Layer Resolution | 20 - 200 microns (0.0007 - 0.008 inches) |
Details EMC, electrical safety, and potential hazards from power and components.
Guides users through initial printer setup: build plate, print cores, and material loading.
Overview of Ultimaker Cura interface and workflow for preparing 3D models for printing.
Explains prepare, preview, and monitor stages in Ultimaker Cura for the printing process.
Details active and manual leveling procedures to ensure proper build plate adhesion.
Addresses common error codes, print core recognition problems, and clogs.
Solutions for issues like poor adhesion, warping, and print quality defects.
Solutions for PVA grinding and under-extrusion issues related to material handling.
To Next Page
