Ultimaker S3 User Manual

Ultimaker S3 and Ultimaker S5 user manual 25
5.1 Update the rmware
Periodically, a new version of the Ultimaker S3 / S5 rmware is released. To ensure that your Ultimaker S3 / S5 is
equipped with the latest features it is recommended to keep the rmware updated to the latest version.
Update over the network
If the Ultimaker S3 / S5 is connected to a network, it automatically checks for available rmware updates. When
a new rmware is available, the printer will prompt you to download and install it via the touchscreen interface.
Alternatively, check for updates manually by navigating to System → Maintenance → Update rmware.
Do not power o the printer during the rmware installation.
Update using a USB stick
If your Ultimaker S3 / S5 is not connected to a network, you can update to the latest rmware via USB. The rmware
les are found on the Ultimaker website:
1. Navigate to ultimaker.com/rmware, and select your printer
2. Download the rmware image and store it in the root directory of your USB stick
3. Insert the USB stick into the USB port of the printer
4. Go to Preferences → Maintenance → Update rmware and select the new rmware in the update menu
5.2 Material handling and storage
Opened material spools must be stored properly when not in use. If material is stored incorrectly, it may aect its
quality and usability.
The optimal storage temperature for PLA, Tough PLA, Nylon, CPE, CPE+, PC, TPU 95A, PP, and Breakaway is between
-20 to +30 °C. For ABS, the advised temperature is between 15 and 25 °C, and for PVA 0 to 30 °C. Furthermore,
a relative humidity of below 50% is recommended for PVA, TPU 95A, PP, and Breakaway. If these materials are
exposed to a higher humidity, the quality of the material can be aected.
To keep your materials in optimal condition, opened spools should be stored:
• Cool and dry
• Out of direct sunlight
• In a resealable bag
To minimize moisture absorption, store the material in a resealable bag including the supplied desiccant (silica
gel) directly after printing.

Ultimaker S3 Specifications

General

Build Volume	230 x 190 x 200 mm
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Number of Print Heads	2
Print Speed	Up to 24 mm³/s
Heated Bed	Yes
Dual Extrusion	Yes
Operating Temperature	15 - 32 °C
Nozzle Diameter	0.4 mm
Connectivity	Wi-Fi, USB, Ethernet
Supported Materials	PLA, ABS, Nylon, CPE, PC, TPU, PP, PVA, Breakaway
Touchscreen	Yes
Feeder Type	Dual-geared feeder
Build Plate	Glass
Bed Leveling	Automatic
Power Requirements	100-240 V, 50-60 Hz
Layer Resolution	20 - 200 microns (0.0007 - 0.008 inches)