Ultimaker S3 - Default Chapter; Table of Contents

Ultimaker S3 and Ultimaker S5 user manual 1
Table of contents
1. Safety and compliance
1.1 Safety messages 4
1.2 General safety information 4
1.3 Hazards 4
1.4 Health and safety 5
1.5 FCC / ISED regulatory notices 6
2. Introduction
2.1 Main components 8
2.2 Specications 9
3. Installation
3.1 Unboxing 11
3.2 What’s in the box 11
3.3 Hardware installation 11
3.4 Welcome setup 12
3.5 Firmware update 14
3.6 Install Ultimaker Cura 14
4. Operation
4.1 Touchscreen 16
4.2 Materials 16
4.3 Preparing a print with Ultimaker Cura 17
4.4 Remove the print 19
4.5 Remove support material 20
4.6 Change the printer conguration 21
4.7 Calibration 22
5. Maintenance
5.1 Update the rmware 25
5.2 Material handling and storage 25
5.3 Maintenance schedule 26
6. Troubleshooting
6.1 Error messages 28
6.2 Print core troubleshooting 28
6.3 Print quality issues 28
7. Warranty
7.1 General 31
7.2 Conditions 31
7.3 Notication 32
7.4 Exclusions 32
7.5 Applicable law and competent court 32