Need help?Do you have a question about the Ultimaker ORIGINAL+ and is the answer not in the manual?
Instructions for assembling the X and Y axes components of the printer.
Guide for assembling the extrusion head, including housing and fan.
Steps for assembling the Z stage, including base plate and heated bed.
Instructions for assembling the material feeder mechanism and filament holder.
Procedure for mounting and connecting the main electronics circuit board.
Instructions for assembling the X and Y axes components of the printer.
Guide for assembling the extrusion head, including housing and fan.
Steps for assembling the Z stage, including base plate and heated bed.
Instructions for assembling the material feeder mechanism and filament holder.
Procedure for mounting and connecting the main electronics circuit board.
General| Print Technology | Fused Filament Fabrication (FFF) |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 2.85 mm |
| Print Speed | 30 - 300 mm/s |
| Software | Cura |
| Dimensions | 357 x 342 x 388 mm |
| Weight | 11.3 kg |
| Build Volume | 210 x 210 x 205 mm |
| Layer Resolution | 0.02 mm - 0.2 mm |
| Supported Materials | PLA, ABS, Nylon |
| Connectivity | SD Card |
| Operating System | Windows, macOS, Linux |
| Operating Temperature | 15 °C - 32 °C |
To Next Page
