Ultimaker 2 Extended User Manual

13
POWER SUPPLY
To finish the installation the power supply will be connected, after which the Ultimaker 2 Extended can be turned on.
Before connecting it, make sure the power switch is in the “o” position.
1. Connect the power cable to the power brick.
2. Plug the power cable in the wall socket and connect the cable at the other end of the power brick to the socket on
the Ultimaker 2 Extended. The flat side of this cable needs to point upwards.

Ultimaker 2 Extended Specifications

General

Brand	Ultimaker
Model	2 Extended
Category	3D Printers
Language	English