Home
Ultimaker
3D Printers
2 Go
Ultimaker 2 Go User Manual
5
of 1
of 1 rating
34 pages
Give review
Manual
Specs
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
12
POWER SUPPL
Y
T
o finish the installation the power supply will be connected. Before connecting it, make sure the power switch is in the
“o
” position.
1.
Connect the power cable to the power brick.
2.
Plug the power cable in the wall socket and connect the other side to the Ultimaker 2 Go. The flat side of this cable
needs to point downwards.
11
13
Table of Contents
Default Chapter
3
Table of Contents
3
1 Ultimaker 2 Go
4
Ultimaker 2 Go at a Glance
5
Specifications
7
2 Getting Started
8
Unboxing
9
Installation
11
First Use
13
3 The Basics
16
Changing Filament
17
Bed Leveling
18
Cura Software
19
Display and Controller
20
4 Maintenance
20
Blue Tape
23
The Feeder
24
Lubricating the Axes
25
Atomic Method
26
5 Help & Support
28
Troubleshooting
29
Support
31
Safety and Compliance
32
5
Based on 1 rating
Ask a question
Give review
Questions and Answers:
Need help?
Do you have a question about the Ultimaker 2 Go and is the answer not in the manual?
Ask a question
Ultimaker 2 Go Specifications
General
Brand
Ultimaker
Model
2 Go
Category
3D Printers
Language
English
Related product manuals
Ultimaker 2+
46 pages
Ultimaker 2 Extended
30 pages
Ultimaker 3 Extended
50 pages
Ultimaker ORIGINAL+
20 pages
Ultimaker S5 Material Station
128 pages
Ultimaker Original
35 pages
Ultimaker S3
33 pages
Ultimaker METHOD XL
29 pages
Ultimaker 3
50 pages
Ultimaker S5
68 pages
Ultimaker S5 Pro Bundle
52 pages
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?
General
