Ultimaker 3 Extended Cleaning

Comments
0 comments
Article is closed for comments.
See more
Recently viewed articles

Replace the radial fans of the Ultimaker 3

Replace the axial fan of the Ultimaker 3

Replace the tube coupling collet of the Ultimaker 3

Replace the clamp clip of the Ultimaker 3

Replace the Bowden tubes on the Ultimaker 3

Clean the feeders on the Ultimaker 3

Lubricate the lead screw of the Z motor on the Ultimaker 3

Ultimaker 3 maintenance schedule
Cleaning the Ultimaker 3 – Ultimaker Support https://support.ultimaker.com/hc/en-us/articles/...
6 of 6 12/15/20, 1:51 PM

Ultimaker 3 Extended Specifications

General

Build Volume	215 x 215 x 300 mm
Layer Resolution	20 - 200 microns
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Operating System	Windows, MacOS, Linux
Print Speed	Up to 24 mm³/s
Software	Ultimaker Cura
Weight	11.3 kg
Print Head	Dual extrusion
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, Nylon, CPE, PVA
Connectivity	USB, Ethernet, Wi-Fi
Display	4.7" color touchscreen
Power Requirements	100 - 240 V / 50 - 60 Hz
Travel Speed	Up to 300 mm/s