EXTRUDER CALIBRATION
When printing with Method XL’s two Performance Extruders, it is crucial to ensure the distance between both extruders is
set correctly. If the extruders are not calibrated, a part may not print successfully.
Calibration should be run if you are noticing any print quality issues, or if the extruders are changed.
You can access the calibration script on the UltiMaker Method XL by going to Settings > Extruder Settings > Automatic
Calibration on the printer’s touch screen.
MAINTAINING THE BUILD PLATE
The surface of the UltiMaker Method XL build plate, known as the Grip Surface, allows for better print adhesion and print quality
compared to other types of build surfaces. However, over time the grip surface can become cracked and damaged. If these
cracks or tears begin to aect print quality, it is time to replace the grip surface. Visit SUPPORT.ULTIMAKER.COM to learn how
to replace the grip surface.
OTHER ISSUES
For help with issues not covered in this chapter, please go to SUPPORT.ULTIMAKER.COM
ULTIMAKER METHOD XL MANUAL PAGE 27
To Next Page
Loading...
