ULTIMAKER METHOD XL MANUAL PAGE 4
SAFETY AND COMPLIANCE
INTENDED USE
The Method XL 3D printer is designed and built for fused lament fabrication within a commercial/business environment.
The mixture of precision and speed makes our 3D printers great for concept models, functional prototypes and small
series production. The user remains responsible to qualify and validate the application of the printed object for its intended
use(s), and the best results will be achieved with materials, especially when material properties are matched with
suggested machine settings.
REGULATORY INFORMATION
FCC SUPPLIER’S DECLARATION OF CONFORMITY
Model Number: Method X
Responsible Party:
MakerBot Industries, LL
55 Water St., 51st Floor, New York, NY 10004
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
FCC CAUTION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. Any changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
FCC RF Exposure Warning:
This product complies with the FCC radiation exposure limits set forth for an uncontrolled environment with a minimum
8
inches spacing requirement between transmitter all person’s body during wireless modes of operation.
To Next Page
Loading...
Need help?
General
