Start
Enter
Batt type
Stop
>3 seconds
DEC. INC.
Start
Enter
DEC. INC.
CHARGING NIMH/NICD BATTERY IN RE-PEAK CHARGE MODE
Re-peak Charge Mode (NiMH and NiCD batteries only): In re-peak
charge mode, the charger can peak charge the battery once, twice or
three times in a row automatically. This is good for confirming the
battery is fully charged, and for checking how well the battery receives
fast charges. A five minute cool-off delay occurs after each re-peak
charge. Press START/ENTER button more than 3 seconds to start the
charging.
The screen displays real-time charging
status. Press BATT TYPE/STOP button to
stop the process.
The audible sound indicates the end of
process.
Re-peak cycle number 1 shows on the
display.
Press the START/ENTER button to make
the re-peak cycle number blink and press
INC. or DEC. button to find the desired
number of times to re-peak charge the
battery. Press the START/ENTER button to
confirm selection.
Set discharge current on the left and final
voltage on the right.
Range of the discharge current is 0.1-1.0A;
range of final voltage is 0.1-25.2V.
Press START/ENTER button for more than
3 seconds to start the program.
N i MH 2 . 0A 9 . 5 2 V
A U T 00 0 : 1 3 0 0 0 00
Elapsed
time
Charged
capacity
Battery
type
Charge
current
Battery
voltage
N i MH R E - P E A K
1
N i MH 2 . 0A 9 . 5 9 V
R P C 00 0 : 3 3 0 0 0 17
-
+
Battery
type
Charge
current
Battery
voltage
Elapsed
time
Charged
capacity
DISCHARGING OF NIMH/NICD BATTERY
NiMH DISCHARGE
0.1A CUT:1.0V
Battery
type
-
+
NIMH/NICD BATTERY PROGRAM
20
To Next Page
Loading...
Need help?
General
