UNI-T UPO2000E Series User Manual

Rising edge, falling edge
H, L
8ns ~ 10s
8ns ~ 10s
Setup/Hold Trigger
Edge Type
Data Type
Setup Time
Hold Time
Positive slope (greater than, less than, specified range)
Negative slope (greater than, less than, specified range)
8ns ~ 10s
Slope Trigger
Slope Condition
Time Setting
Supports standard NTSC, PAL and SECAM broadcast system with
line numbers ranging from 1 ~ 525 (NTSC) and 1 ~ 625 (PAL/SECAM).
Video Trigger
Signal System Horizontal
Scanning
Frequency Range
Code Trigger
Code Setting H, L, X, rising edge, falling edge
Start of frame, error frame, parity error, data
2400bps, 4800bps, 9600bps, 19200bps, 38400bps,
57600bps, 115200bps, user-defined
5 bits, 6 bits, 7 bits, 8 bits
Rs232 Decode
Trigger Condition
Baud Rate
Data Bit Width
Start, restart, stop, lost acknowledgment , address, data, address/data
7 bits, 10 bits
0 to 119, 0 to 1023
1bit to 5bits
Equal to, greater than, less than
I2C Decode
Trigger Condition
Address Bit Width
Address Range
Byte Size
Data Qualifier
Chip select, timeout
80 ns ~ 1s
4 bits to 32 bits
H, L, X
Rising edge, falling edge
SPI Decode
Trigger Condition
Idle Time
Data Bits
Data Setting
Clock Edge
62

UNI-T UPO2000E Series Specifications

General

Brand	UNI-T
Model	UPO2000E Series
Category	Test Equipment
Language	English