19
3.
Model UT805: OPERATING MANUAL
Note
When the Meter is not zero in manual range mode,
you could short circuit the test lead and press REL
to zeroing to increase the accuracy.
When DC voltage measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test, and remove the testing
leads away from the input terminals of the Meter.
l
l
Connect the test leads across with the object being
measured as shown in figure 4. The measured value
shows on the primary display and the secondary
display shows the measuring range. The sampling
rate is around 2 times per second.
To Next Page
Loading...
Need help?
General
