UNI-T UTD1000 Series User Manual


UTD1000 User Manual
Function Menu Explanatory NoteSetup
Help
Auto calibration
Version
Bright
ON
OFF
Exit
Sure
Turn the help function on/off.
Cancel auto system calibration.
Run auto system calibration.
Display the software and hardware version of the Oscilloscope.
Adjust the display brightness.
Table 2-14 Utility menu(continued)
Setting the Battery-saving mode
The initial auto power-off time is 10 minutes. To adjust this follow the steps below :
1.Press [USER] for the utility menu.
2.Press [F1] to access the user option menu.
3.Select the energy-save off time with the jog dial.
4.Press the jog dial to confirm until the current menu is closed
Auto Calibration :
You can correct measurement errors caused by environmental changes with the auto calibration function. This process
can be run selectively when necessary. To make calibration more accurate, power on your Oscilloscope and allow 20
minutes to warm up. Then press the [USER] button then [F3] and follow the on-screen prompt to operate.

UNI-T UTD1000 Series Specifications

General

Brand	UNI-T
Model	UTD1000 Series
Category	Test Equipment
Language	English