User’s Manual UTG1000X Series
Instruments.uni-trend.com 10 / 74
briefly grounded to discharge static electricity;
• Ensure all the instruments are properly grounded to prevent the accumulation of static.
1.7 Preparation Work
1. Connecting the power supply wire, plug the power socket into the protective grounding socket;
According to your view to adjust the alignment jig.
2. Press the software switch on the front panel, the instrument is boot-up.
1.8 Remote Control
UTG1000X series function/arbitrary waveform generator supports communication with the computer via USB
interface. User can use SCPI via USB interface and combined with programming language or NI-VISA to remote
control the instrument and operating other programmable instrument which is also supports SCPI.
The detailed information about the installation, remote control mode and the programming, please refer to
UTG1000X Series Programming Manual at the official website http:// www.uni-trend.com
1.9 Help Information
UTG1000X series function/arbitrary waveform generator has built-in help system for each function key and menu
control key. Long press any soft key or button to check help information.
To Next Page
Loading...
Need help?
General
