To... Press...
make an intercom
page
inTErcoM/clEar.
Select the handset you want to talk with,
or
All
to page all handsets at the same time.
cancel a page
End
.
answer a page
inTErcoM/clEar
or
Talk/flaSh
.
end an intercom
call
End
. Both handsets return to standby.
Chain Dialing
If you often have to enter a series of digits or a code number during a
call, you can save that code number to a phonebook entry and use the
phonebook to send the code number.
Enter the code number (up to 20 digits) into the phonebook just like a 1.
regular phonebook entry. Be sure to enter the code number into the
phonebook exactly as you would enter it during a call.
When you hear the prompt that tells you to enter the number, open the 2.
phonebook and find the entry that contains your code number.
Press 3.
MEnu/SElEcT
to send the code. If you change your mind, just close
the phonebook.
Voice Message Notication
If you subscribe to a voice mail service, your phone can notify you ♦
when you have a new message. This feature supports Frequency-
Shift Keying (FSK) notification. Contact your voice mail provider for
information.
♦When you have new messages, the display shows a message icon.
After you listen to your messages, the message icon turns off. If it
doesn’t, you can reset it: With the phone in standby, open the menu
and select
Global Setup
; select
VMWI Reset
, then select
Yes.
USING THE ANSWERING SYSTEM
Answering System Options (
Ans. Setup
)
You can set or change the answering system options from any handset.
Just open the menu and select
Ans. Setup
. Select one of the following:
Security Code
Enter a 2-digit PIN so you can access your answering system
from any touch-tone phone (see p. 18).
To Next Page