Screening Your Calls
You can use the answering system for call screening. While the system
takes a message, you can listen on the base speaker (if you turn on
Call
Screen)
or from a handset. Only one handset can screen calls at a time.
If another handset tries to screen calls, it beeps and returns to standby.
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller
over the speaker.
Press
MESSagE/MuTE
.
answer the call NA Press
Talk/flaSh
.
mute the call screen without
answering(if you mute the call
screen, the system continues
taking the message:
it just stops playing through the
speaker).
Press
Play/SToP
.
Press
End
or return
the handset to the
cradle.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone.
Before you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select
Ans. Setup
, then select
Security Code
. Use the number keypad to enter a two-digit security code
(
00
to
99
). Press
MEnu/SElEcT
when you’re finished.
Remember to make a note of your new security code!
#
Dialing In to Your System
Call your phone number & wait until the system answers. (If the system 1.
is turned off, it answers after 15 rings & sounds a series of beeps.)
During the greeting or beeps, press 2.
#
and immediately enter your
security code. If you enter it incorrectly 3 times, the system hangs up
and returns
to standby.
The system announces the time, the 3.
number of messages in memory, and a
help prompt. It beeps to let you know it's
waiting for a command.
When you hear beeping, enter a 2-digit 4.
command from the chart.
#1 Repeat message
#2 Play message
#3 Skip message
#4 Delete message
#5 Stop playback
#6 Turn the system on
#9 Turn the system off
#0 Hear help prompts
To Next Page
Loading...
