(To AC outlet)
Wall plate
Removing the wall-mount bracket
At the bottom of the base,
pinch the two "nose" of the
wall-mount bracket as
shown, and then slide
the bracket away from
the base.
Place the mounting slots over
the pins on the wall plate.
Slide the base
down to lock it
into place.
Note: Mounting the phone directly on the wall
Be sure the wall is capable of supporting the weight of the phone, and use •
the proper type of anchoring device for the wall material.
Insert two #10 screws (minimum length of 35mm , not supplied) into the •
wall, 100mm apart.
Leave the screw heads 3mm away from the wall to allow room for •
mounting the phone.
Align the mounting slots over the screws and slide the base down into •
place as shown above.
To Next Page
Loading...
