Uniden TRU 8885 Series User Manual

ADDITIONAL INFORMATION [74] www.uniden.com
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register all the handsets you have (see “De-register the handset“ on page 32).
2. Register the handsets by following the steps under "Register the Handset" on
page 68.
Find Handset
To locate the handset, press flash/find hs on the base
when the phone is in standby mode. All registered
handsets beep for 60 seconds, and
Paging appears on
the handset display. To cancel paging, press any key
on the handset or flash/find hs on the base.
ADDITIONAL
INFORMATION

Uniden TRU 8885 Series Specifications

General

Brand	Uniden
Model	TRU 8885 Series
Category	Cordless Telephone
Language	English