118
Operation with a PABX
As soon as a repeater is registered, it will appear in the repeater list under
De-registering a repeater
Operation with a PABX
To find out which settings are required for a PABX, please refer to the PABX user guide.
Setting Tone or Pulse dialling mode
Setting the flash time
Saving an access code (outside line code)
Setting the access code (e.g. "0") for dialling using the fixed line network.
Setting pauses
Settings System Repeater
¤ . . . use to select Settings OK System OK Repeater OK
. . . use to select repeater De-reg. Ye s
¤ . . . use to select Settings OK Telephony OK Dialling
Mode OK . . . use to select Tone or Pulse Select ( = selected)
¤ . . . use to select Settings OK Telephony OK Recall OK
. . . possible flash times are listed . . . use to select flash time Select ( = selected)
¤ . . . use to select Settings OK Telephony OK Access
Code OK . . . then
Fixed line network: ¤ Access external line with: . . . use to enter or change access
code, max. 3 digits
Rule: ¤ For . . . use to select when the access code should be
dialled
Call Lists: The access code will only prefix numbers from a list (list
of answered calls, list of missed calls).
All calls: The access code prefixes all numbers dialled.
Off: The access code is deactivated and does not prefix any
telephone number.
Save: ¤ Save
¤ . . . then
Pause after line seizure: 1 sec
3 secs
7 secs
¤ OK
¤ OK
¤ OK
To Next Page
Loading...
Need help?
General