Unify OpenScape Desk Phone CP400T Installation And Quick Reference Guide

9
DeutschEnglishFrançaisNederlandsItalianoEspañolPortuguês
Installation of the telephone
See also overview on page 2.
Desk Installation
By mounting the stand on the telephone using the long or short end
you can select between 20° and 45° tilt angle:
1. Place the phone upside down on a soft surface and remove all
cables from the phone except the handset cord
d.
2. Insert the stand along the L-shaped bars on the base of the tele-
phone as shown.
3. Slide the stand to the stop at the left until it locks into place.
4. Plug the U
P0/E
cable into the socket on the bottom of the phone
.
Optional Connections
If desired, you can connect further devices to your phone (see also
overview on page 2):
USB slave for PC connection (1st party CTI)
Connection to Headset
Connection to Key Module
If further settings are required for correct operation of the telepho-
ne, please contact your administrator.
long end: 20° short end: 45°
A
B
D
E

Unify OpenScape Desk Phone CP400T Specifications

General

Brand	Unify
Model	OpenScape Desk Phone CP400T
Category	Telephone
Language	English