How to fix Unify OpenScape WLAN Phone WL4 software functions not starting?
If several software application functions on the Wireless Service Gateway (WSG) of your Unify Telephone aren't starting, it could be due to an invalid license or running in demonstration mode for too long. To resolve this, check if the functions start in Demonstration mode. If they do, enter a valid license and restart the module.
Why my Unify OpenScape WLAN Phone WL4 Telephone module is in Boot Mode?
Your Unify Telephone module may be in Boot Mode because no software is installed, or the installed software is malfunctioning. Install new software to resolve this.
Why does software download fail on my Unify OpenScape WLAN Phone WL4 Telephone?
To resolve a software download failure on your Unify Telephone, ensure the URL for the desired software is correct and attempt the download again. The failure may be due to the web server hosting the image file being incompatible with the portable device.
What to do if software downloads aborted on Unify Telephone?
If software downloads are aborted on your Unify Telephone, ensure that the URL to the desired software is correct and retry. This issue can occur if the wrong file was selected for download from an external web server.
How to fix not being able to edit parameters on Unify OpenScape WLAN Phone WL4?
If you cannot edit parameters after logging into the Unify Telephone system, it's likely you're logged in as an auditor. To fix this, close the browser session and log in again as an admin or sysadmin.
General| Wireless Standard | IEEE 802.11 a/b/g/n |
|---|---|
| Battery Type | Li-ion |
| SIP Protocol Support | Yes |
| Operating Temperature | 0°C to 40°C |
| Humidity Range | 10% to 90% non-condensing |
| Audio Codec | G.711 |
| Protocols | SIP, RTP |
| Security | WPA2-Enterprise |
| Headset Jack | 3.5 mm |
To Next Page
