Unipro UniTire V2 - Service; Guarantee; Service and Guarantee

25
Service
The Unipro UniTire pressure gauge has been
carefully designed to give you many years of
untroubled use. There are no parts inside the
case which need service, nor do the units re-
quire any form of maintenance besides battery
change and cleaning.
In the unlikely event that your product fails to
function correctly, it should be returned in its
original packaging to your Unipro dealer.
You can always nd the updated list of world-
wide dealers on www.uniprolaptimer.com.
No responsibility can be accepted for the
product whilst in transport to the factory
or dealer. Customers are therefore ad-
vised to insure the unit during transport.
When seeking service under guarantee, proof
of the date of purchase will be required.
Guarantee
The product is guaranteed against defects in
material and workmanship for two years from
the date of purchase.
The guarantee is void if the product has been
subject to misuse, accident, or negligence,
or has been tampered with or modied in
any way without the written authorisation of
Unipro ApS.
Note: Connecting anything other than
the UniTire handle to the cable may
cause damage to the product which will
not be covered by this guarantee.
Attempted servicing by unauthorized people
may also invalidate this guarantee. Labor and
carriage charges are not covered unless by
local agreement.
Outside Denmark, local warranty liability is
restricted to equipment purchased within the
territory.
Our agents outside Denmark are only under
contractual obligation to service under guaran-
tee equipment sold through them.
Our agents are entitled to make a non-
refundable charge for any service carried out
on other equipment.
This guarantee does not limit your statutory
rights within the country of purchase.
Service and guarantee
Maintenance